Burmester 011 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Burmester 011에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Burmester 011 16 페이지.

THE OPERATING CONTROLS AND THEIR FUNCTIONS

The VOLUME control knob (3) serves to adjust the volume level in 60 precise steps from 00 (off) to 60

(full volume). The various volume levels are indicated by the VOLUME display (6). If the VOLUME

control knob (3) is turned slowly the volume will change in single steps, if turned rapidly volume levels

will change in large increments. The VOLUME control knob (3) is also used to set functions via the

configurations menu.

The various signal inputs of PHONO, CD, TUNER, AUX 1, AUX 2, AUX 3, AUX 4 and TAPE can be

easily selected by turning the INPUT selector knob (16). Whichever input has been chosen will be

indicated in the universal function display window (12). The INPUT selector knob (16) is also used

to set functions via the configurations menu.

SURROUND /

Bringing the SURROUND / PRE AMP switch (13) into the upper (SURROUND) position the preamp

PRE AMP switch

is set to its surround function. This will be indicated by illumination of the red SURROUND LED (15)

as well as the letters SURROUND in the universal function display window (12). In this operating

mode the signals coming from the connected surround processor are looped directly through to the

preamp's outputs.

CAUTION:

In this operating mode all other functions of the 011 are deactivated. The preamp functions can be turned

back on by bringing the SURROUND / PRE AMP switch (13) into the lower PRE AMP position.

MONITOR / SOURCE

Bringing the MONITOR / SOURCE switch (11) into the upper MONITOR position will suppress the signal

switch

path from the source and replay the just recorded signal from the tape. The monitor function is indicated

by an illuminated red MONITOR LED (14). Setting the MONITOR / SOURCE switch (11) into the down

SOURCE position will open the normal signal path from the source again.

MONO / STEREO

Moving the MONO / STEREO switch (7) into the up MONO position will add the signals from right and

switch

left channel to a monophonic signal which will be available at the outputs. The MONO - operating mode

is indicated by an illuminated red MONO LED (8). Moving the switch down to the STEREO position

will reactivate the normal operating mode.

SCHELLACK / RIAA

By bringing the SHELLACK / RIAA switch (5) into the up (SCHELLACK) position the preamp is set for

switch

replaying shellac records. This operating mode is indicated by an illuminated red SCHELLACK LED (4).

CAUTION:

In order to replay records the INPUT selector knob (16) must be set to PHONO.

Setting the switch to the lower RIAA position will allow the playback of regular vinyl LPs conforming to

the RIAA recording standard.