Burmester 911 MK 3 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Burmester 911 MK 3에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Burmester 911 MK 3 8 페이지.

START - UP PROCEDURE

Standard supply

The shipping carton contains:

· 1 power amplifier 911 MK 3

· 1 owner's manual

· 1 AC cord

· 2 adaptor plugs (16)

· 1 remote cable

Packaging

We recommend keeping the original box and packaging material in case of a move or other shipping.

Positioning

Carefully remove the power amp from the box and set it up in an appropriate location. Choose a location

in which air can flow freely around the amp.

Connecting the AMP

Please make sure that the AC mains switch (7) is set to "OFF" and that the AC plug is not plugged

in before hooking the amplifier up. To avoid any mistakes we strongly recommend to follow the hook-up

sequence outlined here.

AC voltage

AC voltage is set by the factory to the correct voltage in the country in which the amp has been purchased.

Should you whish to operate your 911 MK 3 power amp at a different voltage than set by the factory you

can change it using the AC voltage selector (9) on the rear panel.

Whenever re-connecting the 911 MK 3 to the AC outlet you must make sure that the AC selector has

been set the correct voltage:

The setting 230 V is good for AC voltage from 220 V to 240 V and

the setting 115 V is good for 110 V to 120 V.

If you are not sure about the AC voltage in your area it is important that you ask your authorized Burmester

dealer before connecting the amp.

Inputs

The 911 MK 3 has two balanced inputs (4) and (12), which can also be operated in unbalanced mode

sing the two adaptor plugs (16) supplied as standard. However, to make full use of the 911's sonic

capabilities we recommend balanced connections.

CAUTION:

As MONO amp the 911 MK 3 can only be operated in balanced mode!

Outputs

The speaker cables are connected to the binding posts of the loudspeaker outputs (5), (6), (10) and (11).

To ensure unimpeded signal flow we recommend terminating the speaker cables with copper spade

lugs. We strongly advise against banana plugs of any kind. The speaker cables must be correctly

connected to the speakers before hooking them up to the outputs of the 911 MK 3.

CAUTION:

The speaker outputs of power amps like the 911 MK 3 may carry dangerous amounts of voltage!

Remote

This input offers the possibility of using your Burmester pre-amp or D / A converter to remotely switch

the 911 MK 3 on and off. This requires connecting one of the two REMOTE IN - terminals (13) of the

911 MK 3 with the REMOTE OUT - terminal of the pre - amp or DAC using the enclosed remote cable.