Burndy Continental Industries thermOweld ACR-2 지침
{카테고리_이름} Burndy Continental Industries thermOweld ACR-2에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Burndy Continental Industries thermOweld ACR-2 2 페이지. Thermoweld grounding connections
페이지 인쇄thermOweld
INSTRUCTIONS FOR THERMOWELD GROUNDING CONNECTIONS - ACR-1, ACR-2 & AR-1 TYPE MOLDS
ACR-1
Place cable and ground rod into mold. End
of cable should be to center of ground rod.
Insert ground receptacle into mold. Use a
pair of locking pliers or a clamp to prevent
mold from slipping when fired.
ACR-2
Place cable and ground rod into mold. Insert
ground receptacle into mold. Use a pair of
locking pliers or a clamp to prevent mold
from slipping when fired.
AR-1
Place mold onto ground rod. Next
place ground receptacle into mold.
There should be approximately 1/8"
between end of ground rod and end
of receptacle. Use a pair of locking
pliers or a clamp to prevent mold
from slipping when fired.
+1 (918) 627-5210 • 1-800-558-1373 • WWW.THERMOWELD.COM
ELECTRICAL GROUNDING • CATHODIC PROTECTION • ELECTRIC UTILITY • RAIL
®
The Contractors Choice
Tel. +1.800.558.1373
Tel. +1.918.627.5210
www.thermoweld.com
ECN 2552 REV "E" 03/05/13
34-5381-47