Aquasana AQ-UV-10C 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Aquasana AQ-UV-10C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquasana AQ-UV-10C 20 페이지. Whole house uv filter
Aquasana AQ-UV-10C에 대해서도 마찬가지입니다: 작동 및 설치 지침 (16 페이지)

페이지 인쇄

INSTALLATION STEPS

Installation Checks and Options

1. To facilitate future lamp replacements, ensure there is enough space

at the UV Lamp connector end to safely remove the UV Lamp

and/or Quartz Sleeve.

NOTE: Leave at least an additional UV Reactor length to facilitate UV

Lamp and Sleeve removal.

2. The Controller will require a ground fault circuit interrupter (GFCI or GFI)

outlet and should be mounted beside or above the UV Reactor.

3. For water supplies where the maximum flow rate is unknown, a flow

restrictor is recommended so that the rated flow of your particular

Aquasana system is not exceeded. The flow restrictor should be

installed on the outlet port of the UV Reactor.

4. The UV Reactor can be installed

either horizontally or vertically

using the clamp provided.

Vertical installation is the preferred

method with the inlet at the bottom

(UV Lamp connection at the top)

as it allows any air that may be in

the lines to be easily purged

from the system.

Vertical

(preferred)

Horizontal