Aquasana AQ-UV-L420C 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Aquasana AQ-UV-L420C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquasana AQ-UV-L420C 20 페이지. Whole house uv filter

Aquasana AQ-UV-L420C 소유자 매뉴얼
2

PRECAUTIONS

4
Read all precautions and installation instructions carefully and completely

before installing.

Safety Precautions
• ALWAYS disconnect the power
cord from the electrical outlet
before servicing the system.
• NEVER look directly at an
illuminated UV Lamp without
adequate eye protection and
always protect your skin from
direct exposure to the UV light.
Energy given off by the UV Lamp
is harmful to your eyes and skin.
• To avoid possible electrical shock,
use the unit only with a properly
grounded electrical outlet. If
installing on metallic plumbing,
two grounding clamps and #4
copper wire are essential
for safety.
• The UV Filter should be directly
installed into a ground fault circuit
interrupter (GFCI). If the use of an
extension cord is required, the
cord must be manufactured with a
minimum of 16-gauge wire and care
should be taken to avoid potential
tripping hazards.
• NEVER perform any maintenance
to the system unless you are
comfortable in doing so. Contact
the manufacturer for service
instructions if required.
• DO NOT use this system for any
purpose other than what it was
intended for. Misuse of this system
could potentially cause harm to
the user or others.
• DO NOT install this UV Filter
where the line pressure may
exceed 100 psi. The operating
pressure range for this filter is
between 10psi - 100psi.
• Install on cold water lines
only (40° – 90°F).
• Properly tighten all fittings to
ensure a leak-free assembly.
• NSF certified plumber's tape (thread
sealing tape) is the only sealer that
can be used on threaded fittings.
DO NOT use pipe dope or PVC
primer/glue on threaded fittings.
Exposure to these compounds will
damage nipples causing leaks.
• DO NOT plug the unit in if the
system or any of the components
are wet. Aquasana UV Filters are
intended for indoor use only and
away from leaking plumbing.
• In areas with high pressure, a
pressure relief valve and a water
hammer arrestor may be necessary.