Aquasana EQ-1000 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Aquasana EQ-1000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquasana EQ-1000 16 페이지. Whole house water filter
Aquasana EQ-1000에 대해서도 마찬가지입니다: 설치 매뉴얼 (5 페이지), 소유자 매뉴얼 (16 페이지)

페이지 인쇄

INSTALLATION STEPS

Pre-Condition Rhino Tank

NOTE: It's imperative that this system is flushed properly prior to final installation.

The granular carbon used in the bottom tank contains 1-2% by volume of carbon

fines that must be flushed out prior to use. Surge flushing is the best method for

purging these carbon fines from the media bed.

1. Once out of the box, keep the tank upright

at all times as to not apply pressure to divider.

Remove shipping caps from inlet and outlet

ports. Using supplied adapter, connect a

garden hose to the inlet port so the water will

flow into the system and out of the outlet port.

2. Slowly turn faucet on and allow discolored

water to flow from outlet into a suitable

drainage area. The first few gallons will

appear black and cloudy due to

carbon fines.

TIP: You may need to slightly shake

the tank to help remove carbon fines.

3. After an initial 15-minute flushing, begin

a period of "surge flushing" by turning water

supply on for 30 seconds and then off for 30

seconds, repeating cycle for 15 minutes or

until initial surge of water is completely clear

and free from discoloration and cloudiness.

4. Disconnect the system from the garden hose,

be sure the white washers are properly set

inside the inlet and outlet ports, and position

the system for installation.

Select Location

1. Pick an appropriate installation location. Unit must be installed in an

area where the main water line enters your home, before connecting

to the water heater.

2. Turn off the main water source prior to installation. Drain water from

lines to relieve pressure by turning on a faucet inside your home.

NOTE: DO NOT install after the water heater or on the hot water line.

Components and installation will vary.