Aquasana EQ-AST-WH-C 설치 지침 - 페이지 2

{카테고리_이름} Aquasana EQ-AST-WH-C에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquasana EQ-AST-WH-C 5 페이지. Whole house salt-free water conditioner
Aquasana EQ-AST-WH-C에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지), 소유자 매뉴얼 (12 페이지)

페이지 인쇄

Safe, effective scale prevention

without the use of chemicals or salt.

Direction of flow

26"

Shut-off valve

5-micron pre-filter

Contents

EQ-AST-WH

EQ-AST-WH-C

5-micron pre-filter unit

—OR—

Model: EQ-PRE34PTW

All installation components included.

EQ-AST-WH

48"

These items included with standalone systems.

Install kit:

1) filter housing wrench

2) ball type shut off valve

Replace:

3) support bracket

EQ-304

4) 3/4"x3" nipples (4)

(4-pack)

5) unions (2)

6) hose adaptor

Installation

1. KEEP THE UNIT IN AN UPRIGHT POSITION AT ALL TIMES.

2. Remove the red shipping caps from the inlet & outlet ports on the main housing.

3. Precondition the unit by flushing: It is very important that this system is flushed properly

prior to final installation. Using the supplied adapter, connect a garden hose to the inlet

port so that the water will flow into the system and out of the outlet port. Slowly turn on

the water and allow the cloudy water to flow from the outlet into a bucket or drain. Flush

the NAC tanks for 5-10 minutes. Once the unit has been properly flushed, be sure the white

washers are properly set inside the inlet and outlet ports. Disconnect it from the garden hose

and position it for final installation.

4. Turn off main source water supply prior to installation.

5. Install the unit to the main water supply using the supplied components. Do not over tighten

fittings, as this may cause leakage and broken fittings. Do NOT use pipe dope. The use of

pipe dope voids the warranty. You may use NSF-certified pipe primer, glue and teflon tape.

Leave two-three threads exposed and do not exceed seven layers of teflon tape. More than

seven layers will cause the nipple to crack and leak.

6. IMPORTANT: The inlet piping assembly (valve, pre-filter, main filter unit, union and nipples)

must be firmly braced and supported.

7. Once installation is complete, slowly turn the water on and inspect for leaks.

8. Once the unit is installed and checked for leaks, open the water faucet closest to the

installed unit and allow water to run for 5-10 minutes for the final flushing period.

THIS UNIT MUST BE INSTALLED BY A

LICENSED PLUMBER TO VALIDATE THE WARRANTY

– check operating specifications before installing