Aquasana EQ-AST-WH-C 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Aquasana EQ-AST-WH-C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquasana EQ-AST-WH-C 12 페이지. Whole house salt-free water conditioner
Aquasana EQ-AST-WH-C에 대해서도 마찬가지입니다: 설치 지침 (5 페이지), 소유자 매뉴얼 (12 페이지)

페이지 인쇄

INSTALLATION STEPS

Pre-Condition Salt-Free Water Conditioner

NOTE: It's imperative that this system is flushed properly prior to final installation.

1. Once out of the box, keep the tank upright

at all times as to not apply pressure to

divider. Remove shipping caps from inlet

and outlet ports. Using supplied adapter,

connect a garden hose to the inlet port

so the water will flow into the system

and out of the outlet port.

2. Slowly turn faucet on and allow

discolored water to flow from

outlet into a suitable

drainage area.

TIP: You may need to slightly shake

the tank to help flush the system.

3. Flush the tank for 5-10 minutes.

4. Disconnect the system from the garden

hose, be sure the white washers are

properly set inside the inlet and outlet

ports, and position the system

for installation.

Select Location

1. Pick an appropriate installation location. Unit must be installed in an

area where the main water line enters your home, before connecting

to the water heater.

2. Turn off the main water source prior to installation. Drain water from

lines to relieve pressure by turning on a faucet inside your home.

NOTE: DO NOT install after the water heater or on the

hot water line. Components and installation will vary.