Burners FV-15 사용 설명서 - 페이지 3

{카테고리_이름} Burners FV-15에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Burners FV-15 4 페이지. Vapor propane hand torch

DO NOT USE A MATCH OR ANY OTHER OPEN FLAME TO DETECT

FOR GAS LEAKS

DO NOT OPERATE OR ATTEMPT TO LIGHT OR OPERATE THIS

TORCH IF THERE IS ANY EVIDENCE OF A GAS LEAK OR YOU

SMELL GAS

If a leak is discovered, immediately turn OFF the gas valve on the propane cylinder.

LIGHTING INSTRUCTIONS

Before you begin ...

Make sure you have followed the SET-UP INSTRUCTIONS completely.

SLOWLY open the gas valve on the propane supply cylinder. Check all connections on the

torch, hose and cylinder for leaks, using a soapy water solution or a suitable gas leak detec-

tion solution (available from your local LP Gas supplier). Watch all connections carefully. If

bubbles appear, a leak is present in that area. Shut OFF the gas supply valve on the propane

cylinder

DO NOT OPERATE OR ATTEMPT TO LIGHT OR OPERATE THIS

TORCH IF A LEAK IS PRESENT

Open the gas control valve on the torch 1/8 of a turn, or until a small amount of gas begins to

escape from the torch. Using the flint striker supplied with your torch kit, ignite the gas at

the burner head end of the torch.

NEVER USE A MATCH OR CIGARETTE LIGHTER TO IGNITE THE GAS

– THIS CAN LEAD TO SERIOUS BURNS AND INJURIES.

DO NOT ATTEMPT TO IGNITE THE GAS FOR MORE THAN FIVE (5)

SECONDS

If you cannot light the torch within 5 seconds, turn OFF both the gas control valve on the

torch and the gas supply valve on the propane cylinder. Adjust the size of the flame by using

the adjusting knob on the LP (propane) pressure regulator or gas control valve on the torch.

IMPORTANT PERFORMANCE NOTE

The CGA-510 cylinder connector may be equipped with a safety device known as an Excess

-Flow Safety Check. This safety device prevents large amounts of propane from escaping if

there is a hose failure. This safety device may activate when you first turn ON the pro-

pane gas supply. To correct this problem, simply

the propane cylinder, wait 15 seconds, and then very slowly open the propane supply valve.

This should return the torch system to a normal performance level.

If your torch is still not performing at a normal level, have your local propane supplier verify

that your propane supply cylinder is operating correctly.

SHUT-OFF INSTRUCTIONS

Turn OFF the valve on the gas supply cylinder first. Allow all of the gas to burn completely

and the flame to extinguish at the burner head. Turn OFF the gas control valve on the torch.

close the propane gas supply valve

page 3

Pg 3