Burners FV-21 사용 설명서 - 페이지 2

{카테고리_이름} Burners FV-21에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Burners FV-21 4 페이지. Vapor propane hand torch

FOR YOUR SAFETY - If you smell gas

This torch will produce extremely hot flames, and will cause severe

burns to exposed skin.

You must always use hand and eye protection when using this torch. It

is recommended that you use OSHA approved eye protection and

leather gloves whenever using this torch.

DO NOT use this torch in any area containing flammable vapors such as

gasoline, paint thinner, or degreaser.

DO NOT use this torch near flammable material such as dead & dry

weeds, pine needles, sawdust, & paper.

This torch is only intended for outdoor use only.

This torch is designed for use with a vapor withdrawal LPG (propane type

Only allow properly trained adults to operate this torch.

Do not allow children to operate this torch.

SET-UP INSTRUCTIONS

Before you begin ...

Inspect all material for damage.

Make sure all brass connectors are free from breaks or damage.

Make sure torch assembly is not bent or broken.

DO NOT USE THIS TORCH IF ANY PART IS DAMAGED OR BROKEN

You must provide a UL listed LP Gas Hose with 9/16"-18 LH connections, an adjustable

LP Gas (Propane) regulator – for tank pressure inlet service up to, but no more than 30 PSI

outlet pressure rating, and a LPG vapor withdrawal propane supply cylinder. This cylinder

must be approved by the US Department of Transportation for propane service.

Inspect the O-ring (if applicable) on the CGA-510 cylinder connector fitting, on the LPG

(propane) pressure regulator, for damage. If damaged, do not use the torch. Replace the O-

ring.

Connect the CGA-510 cylinder connector fitting to the LPG withdrawal propane supply

cylinder. (Refer to illustration)

DO NOT OVER TIGHTEN

Make sure the torch control valve is turned completely OFF (fully clockwise). SLOWLY

open the gas valve on the propane supply cylinder. Immediately check for any gas leaks on

the torch control valve, the gas hose, and the CGA-510 tank connector fitting using a soapy

water or suitable gas leak detection solution (available at your local LP Gas Retailer).

Shut off all gas supplies.

Extinguish all open flames.

Contact a qualified gas service technician for assistance.

CGA-510) cylinder only.