Diamond 15352502S 운영 및 유지보수 매뉴얼 - 페이지 12

{카테고리_이름} Diamond 15352502S에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond 15352502S 16 페이지.

페이지 인쇄

CHAP. 5 - MACHINE USE

5.1 - OPERATIONAL CHECK

For the 1° use follow these

instructions:

check that installation has been car-

ried out correctly as in chapter 2;

check that the hopper is well fastened

with the lock hand grip (Fig. n°36

ref.1);

check the sliding of the hopper and

that it is free of obstacles on the work

counter for all of its run (Fig. n°37

ref.a);

check that the goods pressing arm

easily rises and lowers so that it is not

impeded in all its movement (Fig. n°

37 ref.b);

check the opening of the thickness

gauge plane by making the numbered

hand grip turn clockwise and counter-

clockwise (Fig. n°38 ref.c);

check that the sharpener is well

fastened to the machine and that it is

easy to extract and free of obstacles

(Fig. n°39 ref.d).

Fig. n°36

Fig. n°37

Fig. n°38

Fig. n°39

5.2 - LOADING AND CUTTING THE PRODUCT

WARNING: The goods to be cut are loaded on the hopper only with the gradua-

ted hand grip at "0" and the motor stopped, being careful with the blade and the

points.

Adhere to the following procedure:

1. Lift the goods presser, load the go-

ods on the hopper, bringing it close to

the thickness gauge, block it with the-

proper toothed arm;

2. regulate the desired thickness of the

cut with the graduated hand grip;

3. assume a correct position to avoid

accident: place the right hand on the

goods presser hand grip and, then

the left hand next to the slice guard to

take the cut product (without tou-

ching the blade); the body must be-

perpendicular to the work plane (Fig.

n°40).

WARNING:

not

positions which bring body parts in

direct contact with the blade (ex.

Fig. n°41);

4. then push the "ON" push-button;

5. push the carriage (hopper + goods

presser arm + stem) gently towards

the blade, without applying excessive

pressure on the goods with the goods

presser arm. The goods will easily

enter the blade, and the slice guided

by the proper sliceguard will detach

and fall on the plane (Fig. n°42);

6. avoid running the slicer when empty;

7. at the end of the cutting operation,

stop the machine by putting the

switch in the "OFF" position and put

the graduated hand grip at "0";

8. Carry out resharpening the blade as

soon as the cut product has a threaded

assume

Fig. n°40

Fig. n°41

Fig. n°42