Panasonic AG-HCK10 사양 시트 - 페이지 2

{카테고리_이름} Panasonic AG-HCK10에 대한 사양 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic AG-HCK10 3 페이지. Camera cable
Panasonic AG-HCK10에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용자 설명서 (4 페이지), 사용 설명서 (11 페이지)

페이지 인쇄
Panasonic AG-HCK10 사양 시트
<<Specification>>
1. Connectors
HR25-9TP-20P (72)
2. Wiring
(1) LVDS differential shield lines : 4 pairs
Impedance : differential 100 ohm
Wire type : #30 or bigger twisted shield wire
(2) Command differential lines : 2 pairs
Wire type : #30 or bigger twisted
(3) Power lines : 2 pcs
Wire type : #24 or bigger (for 3m length), #22 or bigger (for 20m length)
Total impedance has to be less than 1 ohm.
(4) Signal lines : 2 pcs
Wire type : #30 or bigger
(5) Meshed shield
All those lines have to be covered with meshed shield.
The shield has to be connected to the body of the connectors.
3. Note
The signal [SEL_LENGTH] is connected to GND on AG-HCK10 (camera).
In case the AG-HMR10 (Recorder) would detect the GND status on [SEL_LENGTH] signal (that
means the [SEL_LENGTH] line is closed), the parameters inside AG-HMR10 will be set for using
longer cables. (10m – 20m, or 33' – 67')
In case of using shorter cables (3m – 10m, or 10' – 33'), the [SEL_LENGTH] terminal has to be
open.
Hirose Co.
2
2009.12.25 Ver.1