Panasonic AJ-PCD30PJ 사용 설명서 - 페이지 14
{카테고리_이름} Panasonic AJ-PCD30PJ에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic AJ-PCD30PJ 24 페이지. Operating instructions
Panasonic AJ-PCD30PJ에 대해서도 마찬가지입니다: 브로셔 (24 페이지)
페이지 인쇄
Installation
To Mount the device in a Personal Computer 5-type Bay
1
Switch off your PC.
2
Undo the six screws and remove the cover.
3
Mount the device in a 5-type bay on the
personal computer. If attaching with screws,
use the mounting screws (page 7) supplied
with the device.
Please refer to your computer's instruction
manual for guidance in mounting to 5-type
bay drives.
Holes for securing the screws (the
other side is the same.)
<Notes>
The device may not be able to be fastened
securely in some types of personal
computers.
Depending on the type of your PC, there
may not be enough space to fit the device
internally. In this case, use the device
externally.
If all 5-type bays are occupied, you will
need to remove one of the built-in drives to
make room for the device.
The device should be used in a personal
computer whose design allows the front
panel of the drive to be manipulated.
14
(continue)
Cover
4
To be connected by USB 3.0
Connect the B connector of the USB 3.0
cable to the USB 3.0 connector of the device
and then connect the other end of the cable
to the USB 3.0 port on the motherboard of
your PC.
<Note>
When there is no internal USB 3.0 connector
in your PC, run part of the USB 3.0 cable
outside your PC once, and connect the USB
3.0 cable to the USB 3.0 connector on the
back panel.
A point on the USB 3.0 cable approximately
20 cm from the A connector passes over the
notch of the supplied bracket.
About 20 cm
Notch
Put the cable in from above.
After passing the USB 3.0 cable through the
slot for attaching the supplied bracket, insert
the bracket and fix to your PC using the
screws supplied with this product.