AquaScape AquaJet 15000 빠른 시작 매뉴얼 - 페이지 12

{카테고리_이름} AquaScape AquaJet 15000에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaScape AquaJet 15000 12 페이지. Fountain pump

4.4 Fountain Head Operation for AquaJet 600

The Aquajet 600 comes with two separate fountain heads the

attach directly to the divert valve. To attach the fountain head

simply press the head onto the divert valve. To vary the diameter

of the water bell fountain head all you have to do is unscrew the

central part. (Fig. 6)

You can vary the height of the fountain by opening or closing the

divert valve.

5) Maintenance

5.1 Routine Maintenance

• Your Aquascape

tinuous duty without any major maintenance.

• If any reduction in flow is noticed, unplug the pump and

remove it from the pond. Depressing the clips on the pump will

allow access to the main pump chamber. Remove any debris, and if required, remove

the Pump Volute Outlet by turning counterclockwise and pulling off. Inspect the impeller

for blockage.

5.2 Annual Maintenance

• Remove and inspect the impeller by depressing the tabs and removing the Upper Pump

Housing. Remove the Pump Volute Outlet by turning it counter-clockwise. Inspect the

impeller for damage and replace if necessary.

6) Troubleshooting

6.1 Pump is not operating

• Ensure pump is plugged into a properly grounded and operational outlet. Outlet should

be GFI protected. Ensure that the GFI outlet has not reset due to ambient moisture. Press

"Test" and then "Reset" on the GFI outlet.

• Ensure the impeller is able to move freely. The impeller should be able to move with some

effort inside the pump housing. If it is jammed with debris, follow instructions under

Routine Maintenance to expose and check the impeller.

6.2 Reduced flow from pump

• Ensure that the Upper Pump Housing and the Lower Pump Housing is free of leaves

and debris.

• Ensure that the fountain heads are free from any debris or clogs.

Item #99738-39-40.122006

AquaJet

Pump should operate under con-

™

Figure 6

IDD 06124951-ADI B060577