AquaScape AquaJet 2000 교육 및 유지 관리 - 페이지 6

{카테고리_이름} AquaScape AquaJet 2000에 대한 교육 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaScape AquaJet 2000 16 페이지. Pond pump
AquaScape AquaJet 2000에 대해서도 마찬가지입니다: 지침 및 유지보수 매뉴얼 (16 페이지)

페이지 인쇄

• Internal Pump Cleaning

– If you have thoroughly cleaned the filter cage screens

and still have diminished flow rates, then you will need to

remove the pump from the circular base to inspect and

clean the impeller rotor assembly.

– Pull the cage release tabs outward to unlock the upper

pump cage (Ex. 11).

– With the cage tabs released the filter cage can be lifted

to expose the pump (Ex. 12).

– The procedure to remove the pump from its mount

varies depending on the pump model. The 600 and

1300 are easily removed by depressing the tab on the

mounting bracket and sliding the pump forward towards

the water chamber cover (Ex. 13).

– For the 2000 model, remove the two screws securing

the pump holding brackets to allow the pump to be

lifted from the circular base. Please make a note of the

pump bracket orientation prior to removing the screws

so the brackets can be replaced onto the pump in the

same orientation. The power cord can be left in the

strain relief, if desired, in order to simplify reassembly

(Ex. 14).

– While holding the pump securely, rotate the water

chamber cover counter-clockwise so it can be removed

from the pump (Ex. 15).

Ex. 11

Ex. 14

– With the impeller assembly now exposed, it can be

removed from the pump by pulling outward on the

impeller blades.

IMPORTANT: Do not lose the outer rubber

impeller shaft centering bushing (Ex. 16). This

bushing sits inside the water chamber cover

and sometimes it remains in the cover when the cover is

removed (Ex. 17). If, however, this bushing stays on the

impeller shaft, simply slide it off the shaft and set it aside

or replace it in the water chamber cover so the impeller

assembly can be removed from the shaft.

Outer Rubber

Impeller Bushing

Ex.12

– If your rotor assembly impeller and internal pump body

have excessive scale build-up, clean with a mild acid,

such as white vinegar or Aquascape Pump Cleaner

Maintenance Solution (#91143) and a kitchen sponge or

soft bristled brush that won't scratch the stainless steel.

This will remove the scale build-up and allow the pump

impeller to spin like new again (Ex. 18).

Ex.13

• Replacing The Impeller/Rotor Assembly and Water

Chamber Cover

– The impeller assembly is the only moving part on the

AquaJet pump and will experience wear and tear. If

you've cleaned the pump, as described above, and still

experience poor pump performance, it is most likely

time to replace the impeller. Replacing the impeller is

extremely easy. Replacement impeller kits are available

through your Aquascape dealer.

NOTE: The replacement kits include all parts shown. Make

sure to remove all of the original parts from the inside of

the pump before installing the replacement impeller kit

(Ex. 19).

Ex.15

☎

US (866) 877-6637 |

Ex. 16

CAN (866) 766-3426 | aquascapeinc.com

Ex.17

Ex.18