AquaScape Ultra 1500 지침 및 유지 관리 - 페이지 7

{카테고리_이름} AquaScape Ultra 1500에 대한 지침 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaScape Ultra 1500 16 페이지. Fountain and statuary pump
AquaScape Ultra 1500에 대해서도 마찬가지입니다: 설치 및 유지 관리 지침 매뉴얼 (7 페이지), 교육 및 유지 관리 (16 페이지)

페이지 인쇄

Replacing the Impeller

• The impeller assembly is the only moving part on the

Ultra

Water Pump and will experience wear and tear. If

™

you've cleaned the pump, as described above, and still

experience poor pump performance, it is most likely time

to replace the impeller. Replacing the impeller is extremely

easy. Replacement impeller kits are available through your

local Aquascape dealer.

1. Note the orientation of parts in the photo below.

The replacement impeller kits include all parts shown.

Make sure to remove all of the original parts from

the inside of the pump before installing the replacement

impeller kit.

Centering Bushing

Bearing Washer

2. A centering bushing is required on both ends of the

impeller shaft; one bushing is located inside the pump

and an outer bushing sits in the water chamber cover.

3. Slide the ﬁ rst interior bearing washer onto the ceramic shaft.

4. Place the ceramic impeller shaft into the pump, checking

to be sure the centering bushing seats inside the pump.

5. Carefully slide the impeller back onto the shaft. Use

caution: the impeller assembly is magnetic and will be

pulled forcefully back into the pump.

aquascapeinc.com |

CAN 1-866-766-3426 |

Impeller

Ceramic Shaft

US 1-866-877-6637

6. Install second outer bearing washer over the

impeller shaft.

7. Replace water chamber cover containing the impeller

shaft centering bushing by sliding it over the impeller shaft

and then rotating it clockwise to lock it

into place over the tabs on the pump housing.

8. Replace the pre-ﬁ lter sponge and ﬁ lter screen by

snapping them back onto the pump housing.