Diamond PZF/45DS 설치, 사용 및 유지보수 매뉴얼 지침 - 페이지 11

{카테고리_이름} Diamond PZF/45DS에 대한 설치, 사용 및 유지보수 매뉴얼 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond PZF/45DS 20 페이지. Hot pizza former

IV. INSTRUCTION FOR INSTALLATION

When installing this oven, you must comply with the following:

•

By-laws currently in effect.

•

Local building and fire-prevention regulations.

•

Regulations regarding electrical systems.

•

Accident-prevention regulations currently in effect.

Unload the machine using suitable mechanical hoisting equipment.

Unpack the appliance and carefully remove the protective film.

Should any glue remain on the surface, remove it using a suitable, non-corrosive solvent.

Dispose of the packaging in according with applicable current regulations.

Check that the appliance is intact. In the event of any defects or breakages, contact the manufacturer for

instructions.

The appliance should be placed on top of the relative support provided by the company, since this sup-

port has been made in keeping with its characteristics.

If the appliance is placed on top of any other base unit, make sure that it is level and capable of support-

ing the weight (see technical data table).

Carry out this operation with the aid of suitable mechanical hoisting equipment, using the eyebolt that is

provided and which should be screwed onto the top of the equipment after having removed the protective

plug.

Electrical connections must be performed only by a qualified electrician.

The technical data plate located on the back of the appliance contains all the information required for

proper electrical connection.

The appliance must be connected to the mains using a H05 RN-F type power cord.

In order to do that, remove the appliance left side panel, connect the cord to the terminal box and fasten

it with the proper cable glands found on the appliance back.

Connect the appliance to earth and insert it into the unipotential circuit; the terminal for this purpose is to

be found at the rear of the oven and is marked by the international symbol

Connect the appliance to the electricity supply through a double-pole differential magnetothermal circuit

breaker having a contact separation of at least 3 mm on both poles, which is readily accessible and near

to the appliance.

The manufacturer cannot be held liable in the event of failure to comply with the above.

To start off the appliance, follow the instructions contained in the paragraph "Switch on, parameters

setting, switch off".

Check the correct working of all electrical parts, explaining to the user how to best operate the appliance

and carry out all ordinary maintenance and cleaning.