AquaScape 99774 지침 및 유지 관리 - 페이지 7

{카테고리_이름} AquaScape 99774에 대한 지침 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaScape 99774 16 페이지.
AquaScape 99774에 대해서도 마찬가지입니다: 지침 및 유지 관리 (16 페이지)

페이지 인쇄

STEP 6

BRING IN THE TOPSOIL

• Add topsoil to the berm and surrounding area in order to

provide a good substrate for future landscape planting.

STEP 7

BUILD THE RETAINING WALL

• Finish off the berm where the MicroFalls

building a small retaining wall out of boulders. This step

may or may not be needed, depending on the size of the

berm and the transition into the existing landscape.

☎

www.aquascapeinc.com |

is buried by

☎

CAN 1-866-766-3426 |

STEP 8

PLUG IN AND TWEAK THE WATERFALLS

• As soon as the pond is filled and all of the black waterfall

foam is dry, you may plug the pump in and test the

waterfall.

WARNING

Any electrical should be plugged into a GFCI rated

receptacle.

• You can tweak the waterfall flow by placing smaller stones

and gravel on the waterfall cascades. This will change the

appearance and sound of the water. Have fun playing with

the flow of water coming over the falls until you achieve the

desired effect.

STEP 9

TRIM THE LINER

With everything running, go around the perimeter of the

pond with a pair of scissors and trim off any excess liner,

always leaving several inches above the water level as a

precaution. The remaining liner edges can be covered with

gravel.

NOTE: Do not trim the liner until the waterfall is running and the

pond is filled to the desired level. Prematurely trimming the liner

may cause leaks!

Trim off any excess liner.

STEP 10

MULCH THE BERM

• The entire area surrounding the MicroFalls

mulched and any surrounding plants added.

US 1-866-877-6637

Cover remaining liner edges with

gravel.

can now be