Diamond GB601W HC 매뉴얼 - 페이지 9

{카테고리_이름} Diamond GB601W HC에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond GB601W HC 13 페이지.

페이지 인쇄

5 INSTALLATION

5.1 CONNECTION DIAGRAM (Fig. 4)

7. electrical connection controlled by omnipolar circuit-breaker with residual current device

8. water tap

9. water supply pipe

10. water drainage pipe

5.2 POSITIONING

The appliance must be installed in a hygienically clean location; avoid premises such as cellars and storerooms,

because poor hygiene promotes the formation and proliferation of bacteria in the appliance.

The appliance can operate at an ambient temperature of between 10°C and 43°C.

The best performance will be obtained by installing the appliance in a place with an ambient temperature of between

10°C and 35°C and a water temperature of between 3°C and 25°C.

Avoid direct exposure to sunlight and do not install near heat sources.

This appliance:

• must be installed in a place where it can be supervised by skilled personnel

• must not be used outdoors

• must not be installed in damp places or where it is liable to be sprayed with water

• must not be cleaned with jets of water

• must be allowed a clearance of least 5 cm all around

5.3 CONNECTION TO THE WATER MAINS

IMPORTANT:

• the appliance must be connected to the water mains by professionally qualified personnel in accordance with the

Manufacturer's instructions

• this appliance must be only be supplied with cold water for human consumption (drinking water)

• the operating pressure must be between 0.1 and 0.6 MPa

• a tap must be installed between the water mains and the feed pipe of the appliance, so that the water supply may be shut off if

necessary

• where the feed water is particularly hard, you are advised to install a polyvalent cartridge filter. Any solid particles (e.g. sand)

may be eliminated by installing a mechanical filter, which must be periodically inspected and cleaned. These devices must

comply with the standards in force in the Country of use

• never turn the water supply tap off when the appliance is working

• only new hose-sets supplied with the appliance are to be used to connect the appliance to water mains, old hose-sets should

not be reused

• Is forbidden install the machine to De-ionized or Reverse Osmosis Water

5.3.a FILLING WITH WATER (Fig. 5)

Insert the special seals provided (12) in the two threaded ring nuts (11) of the water supply pipe (9) supplied with the appliance.

Without exerting excessive force (otherwise the unions could crack), firmly tighten one of the threaded ring nuts on the outlet of

the solenoid valve located in the rear of the appliance. The other threaded ring nut must be screwed to the water tap (8); this

too must be provided with a thread.

5.3.b DRAIN (Fig. 5)

Fix the water drain pipe (10) in the housing provided on the rear of the appliance. Make sure that:

• the pipe is a hose

• the internal diameter is 22 mm, as required

• the water drain hose is not throttled at any point throughout its length

• the drain hose slopes downwards by at least 15%

It is advisable to drain the water straight into an open drain trap.

5.4 CONNECTION TO THE ELECTRICITY MAINS

IMPORTANT:

• the appliance must be connected to the electricity mains by professionally qualified personnel in accordance with the

Manufacturer's instructions

• before connecting the appliance to the electricity mains, make sure that the mains voltage rating corresponds to the value

indicated on the rating plate