AquaScape 91019 지침 및 유지 관리 - 페이지 6

{카테고리_이름} AquaScape 91019에 대한 지침 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaScape 91019 16 페이지. Skimmer and pondless waterfall vault pump
AquaScape 91019에 대해서도 마찬가지입니다: 매뉴얼 (16 페이지)

페이지 인쇄

1. Operation and Maintenance

• Install the right-sized

Multi-Hose based on the

diameter of the tubing you

are using.

• Lower the pump into the skimmer (refer to image) or

Pondless

filter (refer to image) and rotate the Rotational

Ball Output to line up with the tubing. Attach tubing to the

fitting and then tighten a hose clamp (not included) to secure

tubing onto the fitting.

• Plug the pump into an external GFI-rated electrical source.

• If using pipe with a larger

diameter than the smaller

fittings of the Multi-Hose

Adapters, cut off the

smaller section to avoid

any flow restriction.

Skimmer application

Pondless

Waterfall application

☎

US 1-866-877-6637 |

IN-LINE OPERATION

• The AquaSurge

pump can also be operated "in-line"

by attaching a pipe connected directly from the pond

(or aquarium) to the male-threaded pump inlet. In this case

the water must be pre-filtered of debris in order to prevent

any damage to the pump or impeller. The pump must

NEVER be operated dry without water. This pump is water-

cooled and requires water flowing through the pump at

all times for the pump to operate correctly and stay cooled

so it doesn't overheat.

OPERATION AND MAINTENANCE

• Filter Screens – Operating the pump without the filter screen

will allow large debris to enter the pump, causing the pump

to fail and voiding the warranty.

• Filter Screen Cleaning – We recommend inspecting your

AquaSurge

on a regular basis to make sure it is functioning

properly. If you notice the water flow rate diminish it may

be due to the pump's filter screen becoming clogged with

debris. Always disconnect the power before performing

maintenance on the pump. In many cases the clogged

screen can be cleaned by reaching in the filter and

removing, by hand, any debris from the filter screen. If there

is a lot of debris and/or the debris is difficult to clean you

may need to disconnect the threaded collar on the fitting

and remove the pump from the filter for a more thorough

cleaning. A garden hose can be used to spray off any

debris stuck on the filter screen. Be sure to replace the

screen and make sure it is firmly attached to the pump

body before lowering the pump back into the filter box.

☎

CAN 1-866-766-3426 | www.aquascapeinc.com