AquaScape 91019 매뉴얼 - 페이지 5

{카테고리_이름} AquaScape 91019에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaScape 91019 16 페이지. Skimmer and pondless waterfall vault pump
AquaScape 91019에 대해서도 마찬가지입니다: 지침 및 유지 관리 (16 페이지)

페이지 인쇄

1. Installation

• The AquaSurge includes a wide assortment of fittings

to choose from. Select the appropriate fitting or fittings

needed for your application.

• The threaded collar (Ex. 3) on all of the fittings enables the

AquaSurge pump to be installed and removed without the

need for any tools.

NOTE: Do not use tools to install the fittings into the pump

discharge (Ex. 4). Fittings need to be only hand tight.

Threaded collar

Ex. 3

• The extremely versatile rotational ball outlet (Ex. 5)

provides you the ability to adjust the pump discharge to

the perfect position your water feature setup requires.

Tightening the threaded collar (Ex. 5) allows you to

rotate the upper half of the ball. A flat rubber washer seal

(Ex. 6) is included to ensure a hand-tight and leak-free

connection. Make sure this flat rubber washer is in place

before installing the fittings.

Ex. 5

• Install the right-sized multi-hose adapter based on the

diameter of the pipe you are using (Ex. 7).

• If using pipe with a larger diameter than the smaller fittings

of the multi-hose adapter, cut off the smaller section to

avoid any flow restriction (Ex. 8).

Ex. 7

☎

aquascapeinc.com |

CAN (866) 766-3426 |

• Lower the pump into the skimmer (Ex. 9) or Pondless

Waterfall Vault (Ex. 10) and rotate the rotational ball output

to line up with the tubing. Attach tubing to the fitting and

then tighten a hose clamp (not included) to secure tubing

onto the fitting.

Skimmer application

Ex. 4

Pondless

• Plug the pump into an

external GFI-rated electrical

source (Ex. 11).

IN-LINE OPERATION

• The AquaSurge pump

Ex. 6

can also be operated

in-line by attaching a pipe

connected directly from the

pond (or aquarium) to the

male-threaded pump inlet. In this case the water must be

pre-filtered of debris in order to prevent any damage to the

pump or impeller. The pump must NEVER be operated

dry without water. This pump is water-cooled and requires

water flowing through the pump at all times for the

pump to operate correctly and stay cooled so it doesn't

overheat.

Ex. 8

☎

US (866) 877-6637

Waterfall application

Ex. 9

Ex. 10

Ex. 11