Diamond CEG/70 설치 - 사용 - 유지 관리 - 페이지 16

{카테고리_이름} Diamond CEG/70에 대한 설치 - 사용 - 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond CEG/70 19 페이지. Range, gas solid top
Diamond CEG/70에 대해서도 마찬가지입니다: 매뉴얼 (19 페이지)

페이지 인쇄

ELECTRIC COOK TOP/ELECTRIC STOCKPOT STOVE

THE HOTPLATE DOES NOT HEAT.

Possible causes:

Hotplate defective.

ELECTRIC OVEN

THE APPLIANCE DOES NOT HEAT.

Possible causes:

Temperature thermostat defective.

Heating elements defective.

Safety thermostat tripped.

HEATING CANNOT BE ADJUSTED.

Possible causes:

Temperature thermostat defective.

25. REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS

SHUT THE GAS SHUT-OFF VALVE

AND/OR SWITCH THE APPLIANCE OFF

AT THE MAIN SWITCH INSTALLED

UPSTREAM.

AFTER REPLACING A GAS SYSTEM

COMPONENT, CHECK FOR GAS LEAKS

AT CONNECTION POINTS.

DISCONNECT THE APPLIANCE ELECTRIC

SUPPLY, IF PRESENT, BEFORE

CARRYING OUT ANY OPERATION.

AFTER REPLACING AN ELECTRICAL

SYSTEM COMPONENT, CHECK IT IS

CORRECTLY WIRED.

GAS HOB

REPLACING THE GAS TAP.

Remove the control panel.

Remove and replace the component.

Reassemble all parts. For assembly, proceed in

reverse order.

GAS SOLID TOP RANGES

REPLACING THE GAS TAP AND PIEZO IGNITER.

Remove the control panel.

Remove and replace the component.

Reassemble all parts. For assembly, proceed in

reverse order.

REPLACING THE MAIN BURNER, PILOT BURNER,

THERMOCOUPLE AND IGNITER.

Remove the hotplate.

Remove the control panel and internal guards.

Remove and replace the component.

Reassemble all parts. For assembly, proceed in

reverse order.

GAS OVEN

THERMOSTATIC TAP AND PIEZOELECTRIC UNIT

REPLACEMENT

Remove the control panel.

Remove the bulb from its seat on the side of the

oven.

Remove and replace the component.

Reassemble all parts. For assembly, proceed in

reverse order.

REPLACING THE BURNER

Open the oven door.

Remove the floor and the plate positioned on top

of the burner.

Remove and replace the component.

Reassemble all parts. For assembly, proceed in

reverse order.

REPLACING THE THERMOCOUPLE

Remove the control panel.

Open the oven door.

Remove the floor and the plate positioned on top

of the burner.

Remove and replace the component.

Reassemble all parts. For assembly, proceed in

reverse order.

GAS STOCKPOT STOVE