AquaScape 84060 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} AquaScape 84060에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaScape 84060 6 페이지. Color-changing lights
AquaScape 84060에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (6 페이지)
페이지 인쇄
Model
Dimensions
Voltage Min-Max/Tensions Min-Max
Wattage
Lumens
Kelvin Temperature
Color Rendering Index
Beam Angle Spread
Cord Length
Installation
MOUNTING OPTIONS
• Choose the option that works best for each light.
– Removable mounting stand (#84059 and #84060 only)
Remove the threaded nut from the fixture holder and insert holder
into the base. Use the threaded nut to secure the fixture holder
(Ex. 1).
– Landscape stake (#84059 and #84060 only)
Remove the threaded nut from the fixture holder and thread the
stake clockwise into the bottom of the fixture holder (Ex. 2).
– No stand or stake
The lights can be used
without the fixture holder
to allow the fixture to be
disguised between rocks
(Ex. 3).
– Adjusting the light angle
To adjust the angle, push
up or down on the fixture
holder until it "clicks" into the
desired position (Ex. 4).
2
LED Color-Changing Lighting Specs
2-Watt LED Color-Changing Waterfall
and Up Light
2" diameter x 1.25"H
10.8V-15V
2±10%
52 lm (white)
3,000 K (white)
70 (white)
30°
15'
Ex. 1
4.5-Watt LED Color-Changing
Spotlight
3" diameter x 3"H
10.8V-15V
4.5±10%
128 lm (white)
3,000 K (white)
70 (white)
30°
15'
– Waterfall and Up Light Base
(#84057 only)
The pre-installed stand can
be removed for installation in
tight spaces (Ex. 5).
CONNECT LIGHT FIXTURES
• Aquascape color-changing lights include 5-pin, quick-connect fittings to
provide tool-free electrical connections.
WARNING: Do not cut
or remove the quick-
connect fitting or isolation
chamber, as it will damage the
light and void the warranty (Ex. 6).
Ex. 2
• Color-changing splitters and extension cables are available to install
multiple lights. See the recommended products section for available
extensions and splitters.
• Connect lights to Aquascape color-changing splitters and extensions
(Ex. 7).
NOTE: Quick-connect connections must be fully tightened to prevent
Ex. 3
water from entering. Dielectric grease, available at most home
improvement stores, can be used in all connections to further prevent
water infiltration.
• For installations with existing low-voltage lighting or components, split
the power after the transformer, before the color-changing lighting control
hub, to run color-changing light off the existing transformer (Ex. 8).
Ex. 4
☎
☎
US (866) 877-6637 |
8-Watt Color-Changing Spotlight
3" diameter x 3"H
10.8V-15V
8±10%
223 lm (white)
3,000 K (white)
70 (white)
30°
15'
to color
lights
Ex. 7
CAN (866) 766-3426 | aquascapeinc.com
Ex. 5
Ex. 6
to white
lights
Ex. 8