Aquascape Pro 45009 지침 및 유지 관리 - 페이지 6
{카테고리_이름} Aquascape Pro 45009에 대한 지침 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquascape Pro 45009 8 페이지. Adjustable flow pump
페이지 인쇄
Multi-Hose Adapter based
on the diameter of the
tubing you are using.
difficult to use with hose fitting barbs. If this is the case
we recommend heating the hose with the use of a hair
dryer or simply dipping the hose for a few seconds in very
silicone grease or olive oil. We recommend putting the
with a twisting motion pushing it into place.
Pondless
®
filter (refer to image) and rotate the Rotational
Ball Output to line up with the tubing. Attach tubing to
the fitting and then tighten a hose clamp (not included) to
secure tubing onto the fitting.
Skimmer application
6
diameter than the smaller
fittings of the Multi-Hose
Adapters, cut off the
smaller section to avoid
any flow restriction.
OR
Pondless
®
Waterfall application
☎
US 1-866-877-6637 |
on a post, fence or wall.
gasket is in plug port.
In-Line Operation
®
PRO pump can also be operated "in-line"
by attaching a pipe connected directly from the pond (or
aquarium) to the male-threaded pump inlet. In this case
the water must be pre-filtered of debris in order to prevent
any damage to the pump or impeller. The pump must
NEVER be operated dry without water. This pump is water-
cooled and requires water flowing through the pump at all
times for the pump to operate correctly and stay cooled so
it doesn't overheat.
Operation and Maintenance
Remote Control and Receiver Operation
The Receiver includes a
switch that allows the pump to be operated
Position 1 - Operated by Remote Control
O
Position 2 - Bypass the Remote, and operate at
–
full flow-rate
In the event of a power loss when operating in the Remote
Control setting, the pump will revert to the last flow-rate setting.
☎
CAN 1-866-766-3426 | www.aquascapeinc.com