Diamond VK38-200 매뉴얼 - 페이지 3

{카테고리_이름} Diamond VK38-200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond VK38-200 20 페이지.
Diamond VK38-200에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 기술 매뉴얼 (14 페이지), 기술 매뉴얼 (14 페이지)

페이지 인쇄

Thermostat

The thermostat is placed in the control panel, see fig. 2.0.

The thermostat has been pre-set and in most cases it is not necessary to adjust the settings.

When turning on the cabinet the display will show the current temperature in the cabinet.

Display set temperature:

Press this key and the display will show the set temperature. Press the key again to return to

normal reading

Set new temperature:

Press this key and the display shows the set temperature.

Press this key to increase the set temperature.

Press this key to lower the set temperature.

Press this key to save the new settings. The display will flash with the new value and will

then return to normal reading.

Alarm codes:

PF1 Flashing in the display: indicates that the cabinet sensor is defective.

The cabinet will strive to keep the set temperature until it has been repaired.

Fig. 1.9

Fig. 2.0