Chuango DML-100 사용자 설명서 - 페이지 3
{카테고리_이름} Chuango DML-100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Chuango DML-100 7 페이지. Multipurpose sensor
페이지 인쇄
Network Setup
Bluetooth: Select Bluetooth toggle to turn it on, it will automatically search for the device.
Tap to add it to your home Wi-Fi network.
Wi-Fi AP mode: Tap Add Device or "+"in the upper right corner, then select DML-100 under
"Security" .
Press and hold the Configuration Button for 3 seconds to power on the device, wait for the
device to complete a 40-seconds self-test until the indicator light gradient flashes.
Light
Magnet base
Short press the Configuration Button 3 times, the device will enter the WiFi configuration
state. The breathing light goes off to indicate the configuration is successful.
Operation
Press and hold the
configuration button for
On
3 seconds
Press and hold the
configuration button for
Off
3 seconds
Flash on and off for 40
/
seconds
Press the configuration
Gradient flashing
button 3 times
/
Gradient flashing off
On for 1 second then
Press the configuration
gradient flashes
button 5 times
(configuration mode)
Note:
Deleting the sensor on the APP while it's online will also reset it.
Light Status
Meaning
Sensor is powered
on
Sensor is powered
off
Device self-test
Device is under
configuration state
Successfully
connected to the
network
Device reset
Prompt Tone
Power on tone
Power off tone
/
Beep once
Beep twice
Long beep once