Chuango SPS-260 사용자 설명서
{카테고리_이름} Chuango SPS-260에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Chuango SPS-260 3 페이지. Solar-powered siren
페이지 인쇄
Solar-Powered Siren
User Manual
SPS-260
Product Overview
The solar-powered siren is a totally wireless siren, designed to help protect yards, driveways, gardens
and all types of other external locations. The strobe siren is battery powered and kept re-charging by
the built-in solar panel. The signal transmission is all by wireless radio frequency which achieves
significantly wirefree transmission and enhances the flexibility to install. Users can install some outdoor
strobe sirens to deter the intruders in Omni-directional guard.
The strobe outdoor siren can be used as a wireless siren by connecting to the control panel as well as a
standalone alarm system to work with wireless accessories in same frequency by learning.
PCB Layout
Siren Duration Setting
Volume Setting
Power On/Off
9V 6F22
18650
Note:
The status LED will flash once every 5 seconds in arm status. It will not flash when in disarm status.
The siren will sound immediately if the tamper switch is triggered.
External Tamper Switch
Internal Tamper Switch
Learning Button
Status LED Indicator
Alarm LED Indicators
Jumper Setup
Volume Setting
Mute
High
(default)
HIGH
MUTE
LOW
Siren Duration Setting
5
2
minutes
minutes
5MIN
2MIN
30S
Usage
Getting Started
1. Load the 9V battery.
2. Set the volume and duration of the siren.
3. Start to use by pressing the power button on.
Work as a Wireless Siren
Connect to Alarm Panel
Press the learning button (0.5 seconds), the wireless siren goes into
connecting status after one beep is heard. Press
the panel. The wireless siren is connected successfully with the control
panel after another beep.
To give up the connection, press the learning button again to exit.
Note:
Please don't trigger any accessory during connecting with alarm panel.
After connected to the alarm panel, the siren will hoot and the strobe light will flash when the alarm
panel alarms.
Low
HIGH
MUTE
LOW
HIGH
MUTE
LOW
30
seconds (default)
5MIN
2MIN
30S
5MIN
2MIN
30S
or
Arm
button on