AQUASONIC AQ339 설치 매뉴얼 - 페이지 9
{카테고리_이름} AQUASONIC AQ339에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AQUASONIC AQ339 12 페이지. Underwater loudspeakers
AQUASONIC AQ339에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지)
페이지 인쇄IN-WALL INSTALLATION
Use a wrench and a Phillips screwdriver to tighten the wire clamp. When fully tightened, the wire clamp
4
should be firmly seated in each clamp tab and the speaker should be secure. Pick up the assembly and
insure it is still properly centered in the face ring. If not, loosen the wire clamp and adjust.
Take the end of the speaker wire and pull it through the conduit hole in the back of the niche using
5
a wire puller. Leave 10 to 12 ft. of speaker wire in the niche to allow for easier access during future
servicing of the speaker. Place the speaker inside the light niche.
Note: In actual applications, the niche will already be mounted in the wall of the pool.
Carefully set the lock tab located on the bottom of the face ring behind the receiving plate located on
6
the bottom of the niche. Align the bolt/rubber washer on the face ring with the threaded receiving hole
on the niche. Attach the trim ring securely to the niche by gently tightening the bolt. You are now ready
to connect the speaker to your audio system.
9
www.clarksynthesis.com
Underwater Speaker