Panasonic WV-SP508 설치 매뉴얼 - 페이지 17
{카테고리_이름} Panasonic WV-SP508에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WV-SP508 36 페이지. Ip video cameras
Panasonic WV-SP508에 대해서도 마찬가지입니다: 사양 (2 페이지), 설치 매뉴얼 (40 페이지), 통합 참고 사항 (8 페이지)
페이지 인쇄
<Rear view>
<WV-SP509>
Network connector
Access indicator
(blinks when accessing)
Link indicator
(lit when linking)
Monitor for adjustment
Output connector
EXT I/O terminals
<WV-SP508>
Network connector
Access indicator
(blinks when accessing)
Link indicator
(lit when linking)
Monitor for adjustment
Output connector
EXT I/O terminals
About the [INITIAL SET] button
After turning off the power of the camera, turn on the power of the camera while holding down this
button, and wait for around 5 seconds or more without releasing this button. Wait around 2 minutes
after releasing the button. The camera will start up and the settings including the network settings
will be initialized. Do not turn off the power of the camera during the process of the initialization.
Before initializing the settings, it is recommended to write down the settings in advance.
10BASE T/100BASE-TX
AUDIO OUT
MIC/LINE IN
ACT
LINK
SD CARD/ABF
MONITOR OUT
EXT I/O
GND 4 3 2 1
ALARM IN 1/DAY/NIGHT IN
ALARM IN 3/AUX OUT
ALARM IN 2/ALARM OUT
10BASE T/100BASE-TX
ACT
LINK
ABF
MONITOR OUT
EXT I/O
GND 4 3 2 1
ALARM IN
AUX OUT
ALARM OUT
Audio output connector
Microphone/line input connector
INITIAL
SET
INITIAL SET button
POWER
Power indicator
12V = IN
12 V DC power supply terminal
SD memory card error indicator/
ABF indicator (blinks when ABF is being
activated)
INITIAL
SET
INITIAL SET button
POWER
Power indicator
12V = IN
12 V DC power supply terminal
ABF indicator
(blinks when ABF is being activated)
17