Panasonic WV-SP508 설치 매뉴얼 - 페이지 27
{카테고리_이름} Panasonic WV-SP508에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WV-SP508 36 페이지. Ip video cameras
Panasonic WV-SP508에 대해서도 마찬가지입니다: 사양 (2 페이지), 설치 매뉴얼 (40 페이지), 통합 참고 사항 (8 페이지)
페이지 인쇄
n
Connect the power supply.
IMPORTANT:
• The 12 V DC power supply shall be insulated from the commercial AC power.
• The operating sound might be heard when the power is turned on, however it does not indi-
cate any malfunction.
When using 12 V DC power supply*
q Loosen the screw of the power cord plug (accessory).
w Connect the cable of the 12 V DC power supply* to the
power cord plug.
Strip 3 mm to 7 mm {1/8 inches to 9/32 inches} from the
end of the wire, and twist the stripped part of the wire
sufficiently to avoid short circuit.
Specification of cable (wire): 16 AWG - 24 AWG
• Check whether the stripped part of the wire is not
exposed and is securely connected.
e Tighten the screw of the power cord plug.
(Recommended tightening torque:
0.34 N·m {0.25 lbf·ft})
r Connect the power cord plug to the 12 V DC power sup-
ply terminal on the rear of the camera.
* ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY
(UL 1310/CSA 223) or LIMITED POWER SOURCE (IEC/
EN/UL/CSA 60950-1).
IMPORTANT:
• Be sure to use the power cord plug provided with this product.
• Be sure to fully insert the power cord plug into the 12 V DC power supply terminal. Otherwise,
it may damage the camera or cause malfunction.
• When installing the camera, make sure that excessive force is not applied to the power cable.
• Be sure to use an AC adaptor compliant with the Specifications regarding power source and
power consumption (
Single core, twisted
☞
page 32).
10BASE T/100BASE-TX
AUDIO OUT
MIC/LINE IN
ACT
LINK
SD CARD/ABF
MONITOR OUT
EXT I/O
GND 4 3 2 1
ALARM IN 1/DAY/NIGHT IN
ALARM IN 3/AUX OUT
ALARM IN 2/ALARM OUT
To 12 V DC
power supply*
(This illustration represents
WV-SP509.)
12 V DC power
cord plug
(accessory)
(GND)
INITIAL
SET
POWER
12V = IN
(12 V DC)
27