Panasonic WV-SW396 설치 매뉴얼 - 페이지 20
{카테고리_이름} Panasonic WV-SW396에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WV-SW396 40 페이지. Ip video cameras
Panasonic WV-SW396에 대해서도 마찬가지입니다: 사양 (2 페이지), 설치 매뉴얼 (40 페이지), 양이온 (2 페이지), 통합 참고 사항 (8 페이지)
페이지 인쇄
Step 4
Mount the camera on the bracket.
q Attach the housing base to the mount bracket using
the hexagon screws (M5) attached to the housing
base* provided with the mount bracket.
(Recommended tightening torque: 2.45 N·m
{1.81 lbf·ft})
The "REAR" mark of the housing base shall be direct-
ed to the wire hook section.
* Special screw: These screws are hexagon screws.
Use an M5 hexagon wrench.
w Make sure that the projection of the plate spring on
the upper side of the camera is located on the
"START" position. If not, turn the plate clockwise to
locate the projection at the "START" position.
Plate spring
e Connect the safety wire (accessory) to the mount bracket.
Refer to the operating instructions of the mount
bracket for further information about where to con-
nect the safety wire.
Even when not using the optional mounting bracket
(WV-Q122), connect the safety wire near to the cam-
era as shown in the example below.
20
Hexagon screws (M5, 4 pcs.)
attached to the housing base
Wire hook
section
Housing base
Projection
Plate
<Installation example>
r Attach the camera to the housing base. When attach-
ing the camera to the housing base, the positioning
pin shall be on the "REAR" side. Make sure that the
camera is securely attached to the mount bracket by
turning the camera to the direction of the arrow as
illustrated. Then, secure the camera to the mount
bracket with the screws removed when detaching the
housing base.
(Recommended tightening torque: 2.45 N·m
{1.81 lbf·ft})
* Special screw (Fixing screw): These screws are hexa-
gon screws. Use an M5 hexagon wrench.
Overhead view
Positioning pin
When the camera is
attached
Fixing screws
(3 pcs.)
Positioning pin
Safety wire
When the camera is secured
to the mount bracket
Housing base
Camera