Panasonic WV-SW396 설치 매뉴얼 - 페이지 34
{카테고리_이름} Panasonic WV-SW396에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WV-SW396 40 페이지. Ip video cameras
Panasonic WV-SW396에 대해서도 마찬가지입니다: 사양 (2 페이지), 설치 매뉴얼 (40 페이지), 양이온 (2 페이지), 통합 참고 사항 (8 페이지)
페이지 인쇄
Symptom
Live indicator keeps on
blinking orange approx. in 2
seconds intervals.
Live indicator never lights up.
Live indicator keeps on
blinking red.
Live indicator lights red.
Audio input contains noise.
The power cable insulation is
damaged.
The power cable, plug and
connectors get hot during
use.
The power cable gets hot
when bent or stretched.
34
• UPnP
TM
error has occurred since the power is not supplied to the
router.
Turn on the power of the router. Wait until the connections are
established.
• An error has occurred during the port update by the UPnP func-
tion.
If the router in use does not support the UPnP function, perform
the port forwarding setting for the router. In addition, deactivate the
setting of auto port forwarding for the camera.
• UPnP function of the router is disabled.
Refer to the operating instructions of the router to enable the
UPnP function.
• Is "Off" selected for "Link/Access LED" on the "Basic" page?
Select "On" or "On(Access)" for the indicator setting.
• The camera may be out of order.
Contact your dealer.
• R efer to the readme file on the provided CD-ROM for further infor-
mation after checking the displayed contents of the "Maintenance"
page - the [Status] tab - "Self check" of the setup menu.
• Isn't the write protect switch of the inserted SDHC/SD memory
card set to "LOCK"?
Unlock the write protect switch of the SDHC/SD memory card.
• H asn't the inserted SDHC/SD memory card been formatted on a
PC?
Use an SDHC/SD memory card formatted on the camera.
Or install the software to format the SDHC/SD memory card on
the PC. Refer to our website (http://panasonic.net/pss/security/
support/info.html) for further information about the supported soft-
ware.
• I sn't the inserted SDHC/SD memory card faulty?
Replace the card with a normal one.
• Check the following.
• G rounding of the camera, a switching hub or peripheral devices
are not done.
• The camera is used near an electrical power line.
• T he camera is used near a device which produces strong mag-
netic field or radio waves (such as near a TV/radio antenna, a
motor of an air conditioning system, a transformer, etc.)
When audio input still contains noise even after checking the
above possibilities, use a powered microphone or connect audio
output with low output impedance.
The power cable and connectors are worn out.
This may result in electric shock or a fire.
Unplug the power cable from the AC outlet immediately, and refer
to qualified service personnel.
Cause/solution
Reference
pages
−
Operating
Instructions
(included in
the CD-ROM)
−
Operating
Instructions
(included in
the CD-ROM)
−
Operating
Instructions
(included in
the CD-ROM)
12
–