Panasonic WVNP1000 - NETWORK CAMERA 사용 설명서 - 페이지 20
{카테고리_이름} Panasonic WVNP1000 - NETWORK CAMERA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WVNP1000 - NETWORK CAMERA 28 페이지. Ip video cameras
Panasonic WVNP1000 - NETWORK CAMERA에 대해서도 마찬가지입니다: 매뉴얼 (2 페이지), 통합 참고 사항 (8 페이지)
페이지 인쇄
Basic operation
The following are descriptions of how to configure each setup item on the [Camera] tab using the operation buttons on the
camera.
Notes:
• The illustrations below are the examples of the [Camera] tab pages to be displayed on a video monitor.
• The images of the setup menus in these operating instructions are of the WV-NP1004.
Step 1
Hold down the [SET] button for around 2 seconds.
→ The top page will be displayed.
MODEL
WV-NP1004
CAMERA
BACK-FOCUS
SPECIAL
NETWORK
END
SETUP DISABLE
Step 2
Move the cursor onto "END" by press the [UP] or [DOWN]
button.
Step 3
Press the [SET] button after moving the cursor onto
"SETUP" by pressing the [RIGHT] button.
→ The "DISABLE" indication will change into "ENABLE"
and the settings will become editable.
MODEL
WV-NP1004
CAMERA
BACK-FOCUS
SPECIAL
NETWORK
END
SETUP ENABLE
Step 4
Move the cursor onto the desired setup item and press the
[SET] button.
→ The setup page of the selected setup item will be dis-
played.
**CAMERA SETUP** 1/2
CAMERA ID
OFF
ALC/ELC
ALC
SHUTTER
OFF
AGC
ON(HIGH)
SENS UP
OFF
SYNC
INT
WHITE BAL
ATW1
DNR
HIGH
BW MODE
PRIVACY ZONE
OFF
EL-ZOOM
OFF
20
**CAMERA SETUP** 2/2
STABILIZER
OFF
RET TOP END
Step 5
Configure the settings for each item.
Select setup item: Move the cursor by pressing the [Up]
or [Down] button.
Change the parameter: Press the [Left] or [Right] button.
Display the detailed settings page of the setup item:
Press the [SET] button when the setup item with the
[O] mark is selected.
Go back to the previous page: Move the cursor onto "RET"
and press the [SET] button.
Go back to the top page: Move the cursor onto "TOP" and
press the [SET] button.
Step 6
To exit from the SETUP menu and display images from the
camera: Move the cursor onto "END" and press the [SET]
button.
Notes:
• To prevent erroneous operations, the "DISABLE" indica-
tion will always be displayed when the top page is dis-
played. To operate the SETUP menu, switch the "DIS-
ABLE" indication to the "ENABLE" indication first.
• The cursor position will be displayed highlighted.