Panasonic CT-20G7D 사용 설명서 - 페이지 14
{카테고리_이름} Panasonic CT-20G7D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic CT-20G7D 36 페이지.
페이지 인쇄
REMOTE CONTROL OPERATION
The Universal Remote Control can be programmed to operate many manufacturers'
components,
using the component
function buttons for VCR, DVD, CABLE or DBS. Follow the procedures for programming
your Remote Control with or
without a code for the component.
Default Modes For Remote Control
Determine the manufacturer of the component and look in the table for the code.
Procedure
•
Confirm that the external component is plugged in and operating.
•
Turn the component off.
ACTION
•
Press
and _
together, for at least 5 seconds.
•
Press appropriate component button on the Remote Control VCR, DVD, CABLE or DBS.
•
Enter the 3-digit component code using the Remote Control numeric keypad (0 - 9 buttons).
•
Press the Remote Control _
to test the component. If the procedure was successful, the component will turn on.
This procedure
searches
all codes and is called the "sequence
method."
•
Confirm that the external component is plugged in and on.
•
Turn the component off.
ACTION
•
Press
and _
together, for at least 5 seconds.
•
Press appropriate component button on the Remote Control.
•
Press VOL _
to move forward to the next code. Press _
VOL
to move backward.
•
Press the Remote Control _
to test the component. If the procedure was successful, the component will turn on.
Note:
Repeat the above steps until the component
code is found. It may take many attempts before the correct code
is found.
ACTION
After the code is found, press
to store the code.