Diamond Audio D365C 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Diamond Audio D365C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Audio D365C 4 페이지. D series

MIDRANGE MOUNTING

Determine a location in the door that will accept

the size of your new speaker. Remove the door

panel from the door and check for clearance in

the intended speaker location while operating

window all the way up and down. Avoid cutting

any structural metal to mount the speakers or

to accommodate additional depth. If depth or a

flat surface mount are an issue, please seek the

skills of a professional installation technician.

If you are mounting the speakers in the rear of the

vehicle, there are often two options for achieving

a good mount. Some speakers mount from the top

side (from the interior) while other applications have

the speakers mounted from the bottom side (from

the trunk). In either case, a flat mounting surface and

a good seal are still extremely important.

TWEETER MOUNTING

When flush mounting tweeters, make sure the desired

location can accommodate the hole size and depth

required. Mount the cup using provided hardware. Mount

surface cup at desired angle with provided screws in

tweeter mounting kit. Route speaker wires through

tweeter cup, connect tweeter to wires, and snap tweeter

into cup by aligning the notches.

Mounting Hole size: 1.36" (34.5mm) Dia.

(a division of CV & DA Holdings, lnc.)

D Speaker Manual 2013.indd Spread 4 of 4 - Pages(4, 5)

SYSTEM CONNECTION

D65C

Each D crossover has a tweeter attenuation jumper and a phase adjustment located under the

removable cover. Choose "0" or "-2dB". If the tweeter is significantly closer to the listener than the

midrange, this adjustment should improve the frequency level balance.

D365C

Each DAT3X crossover has a tweeter phase switch located under the removable cover. Choose "0"

or "180". This adjustment may improve frequency response depending on the tweeter mounting

location relative to the midrange.

DAT3X

INPUT

WOOFER

MID

TWEETER

(a division of CV & DA Holdings, lnc.)