Panasonic CT-2772SD 사용 설명서 - 페이지 12
{카테고리_이름} Panasonic CT-2772SD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic CT-2772SD 50 페이지. 36" diagonal stereo monitor-receiver
Panasonic CT-2772SD에 대해서도 마찬가지입니다: 사용 설명서 (50 페이지)
페이지 인쇄2 Tuner Picture In Picture (PIP) Operation
Note:
PIP Operation with a VCR and Cable Box
This television includes a two tuner Picture In Picture (PIP) feature. This allows
watching two (2) live broadcasts at the same time without or with an external video
source (VCR).
Without A VCR (External Video Source)
Procedure
With A VCR (External Video Source) And Cable Box
Connect your television to a VCR and Cable Box, as shown.
CONNECTIONS ON BACK OF TV
COMPONENT
VIDEO INPUT
TO AUDIO
AMP
INPUT 1
L
ANT IN
R
INPUT 2
CABLES NOT SUPPLIED
Note:
Procedure
Press the PIP button on the Remote Control to display the PIP frame.
Note:
To view scrambled channels through your Cable Box in the PIP frame:
Note:
Refer to the FEATURE COMPARISON CHART on page 3 for your television PIP capability.
1.
Connect incoming cable to antenna (ANT) input on back of TV.
2.
Press the PIP button on the Remote Control to display the PIP frame.
Note:
The audio is for the Main Picture only.
3.
Choose channels for the PIP frame by pressing the Remote Control PIP CHANNEL
up/down buttons.
Choose channels for the Main Picture by pressing the Remote Control
4.
CH up/down buttons or by using the numeric keypad.
R
AUDIO
L
P
P
Y/VIDEO
R
B
S-VIDEO
R
AUDIO
VIDEO
L
The Remote Control must be programmed with supplied codes to operate the VCR and Cable
Box. See Programming the Remote Control in the Remote Control Quick Reference Guide.
The audio is from the Main Picture only.
1.
Press the TV/VIDEO button on the Remote Control to select the same video input to
which your cable box is connected.
2.
Verify the CABLE BOX and VCR are ON and the VCR tuned to channel 3.
3.
Choose channels for the PIP frame by pressing the CBL button on the Remote Control
and using the numeric keypad or PIP CHANNEL up/down buttons.
4.
Choose channels for the Main Picture by pressing the TV button on the Remote
Control and using the numeric keypad or CH up/down buttons.
The SWAP button switches the on screen PIP and Main Picture source. Press the
RECALL button for PIP and Main Picture source status.
2 T
P
I
UNER
ICTURE
N
VIDEO OUT
AUDIO OUT
ANT IN
P
(PIP) O
ICTURE
PERATION
VCR
CABLE BOX
ANT OUT
ANT IN
L
R
ANT OUT
Cable spliltter
(not supplied)
Incoming Cable
11