Panasonic CT-27G21 사용 설명서 - 페이지 6

{카테고리_이름} Panasonic CT-27G21에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic CT-27G21 40 페이지. Panasonic ct-27g21: user guide
Panasonic CT-27G21에 대해서도 마찬가지입니다: 사용 설명서 (40 페이지)

Installation
Receiver
Locatiol=
This unit is intended to be used with aL,opuonat stand or entertainment center. C;uf_sult your dealer for available options.
Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the
screen.
Use of some types of fluorescent lighting can reduce remote control transmitter range.
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or
moisture.
To insure optimum color purity do not position magnetic equipment (motors, fans, other speakers, etc.) nearby.
Optional External Equipment
Connections
The Video/Audio connections between components can be made with shielded video and audio cables. For best perfor-
mance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic
supply house.
Before you purchase any cables, be sure you know what type of output and input connectors your various components
require. Also determine the length of cable you'll need.
AC Power Supply Cord
CAUTION:
TO PREVENT
ELECTRIC
SHOCK, MATCH WIDE BLADE OF PLUG TO
WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE THIS (POLARIZED)
PLUG WITH A RECEPTACLE
OR OTHER OUTLET
UNLESS THE BLADE CAN BE
FULLY INSERTED TO PREVENT BLADE EXPOSURE.
Remote Control Battery Installation
Batteries: Use two "AA" batteries.
1.
Turn the Transmitter face down. To remove top cover, press down on
marking and slide cover off in the direction indicated.
2.
Install the batteries as shown in the battery compartment. (Polarity (+) or
(-) must be correct.)
3.
Replace the cover and slide in reverse until the lock snaps.
Precaution
on Battery
Use
Incorrect installation can cause battery leakage and corrosion that will
damage the Remote Control Transmitter.
Observe the Following Precautions:
1.
Batteries should be replaced as a pair. Always use new batteries when
replacing the old set.
2.
Do not combine a used battery with a new one.
3.
Do not mix battery types (Example: "Zinc Carbon" with "Alkaline").
4.
Do not attempt to charge, short-circuit, disassemble, heat or burn used
batteries.
5.
Battery
replacement
is necessary
when
Remote
Control
reacts
sporadically or stops operating the Receiver.
Helpful Hint:
Polarized Plug
m
m
Press Down Here
And Slide Cover
Back
..
°.
\
-6-