Panasonic CT-27G30CT 사용 설명서 - 페이지 5

{카테고리_이름} Panasonic CT-27G30CT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic CT-27G30CT 36 페이지.
Panasonic CT-27G30CT에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지)

페이지 인쇄

Installation

Receiver Location

Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the

screen.

Use of some types of fluorescent lighting can reduce remote control transmitter range.

Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or

moisture.

To insure optimum color purity do not position magnetic equipment (motors, fan, other speakers, etc.) nearby.

Optional External Equipment Connections

The Video/Audio connections between components can be made with shielded video and audio cables. For best perfor-

mance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic

supply house.

Before you purchase any cables, be sure you know what type of output and input connectors your various components

require. Also determine the length of cable you'll need.

AC Power Supply Cord

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE

SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE THIS (POLARIZED)

PLUG

WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY

INSERTED TO PREVENT BLADE EXPOSURE.

Polarized Plug

Remote Control Battery Installation

& Replacement

Battery Installation

Batteries: Use two "AA" batteries.

1. Turn the Transmitter face down. To remove bottom cover, press down

on marking and slide cover off in the direction indicated.

2..Install

the batteries as shown in the battery compartment. (Polarity (+)

or (-) must be correct.)

3. Replace the cover and slide in reverse until the lock snaps.

.Precaution

on Battery Use

Incorrect installation can cause battery leakage and corrosion that will

damage the Remote Control Transmitter.

Observe the Following Precautions:

1. Batteries must be replaced as a pair.

Do not combine a used battery with a new one.

Do not mix battery types (Example: "Zinc Carbon" with "Alkaline").

Do not attempt to charge, short-circuit, disassemble, heat or burn used

batteries.

Battery

replacement

is necessary

when

Remote

Control reacts

sporadically or stops operating the Receiver.

II IIII

"=F=P-

J,.J

4-J

,=_d=. ,.._..

Press Down Here And

over Back

"":!ii""

-5-