Panasonic CT-32SX31E 서비스 매뉴얼 - 페이지 15
{카테고리_이름} Panasonic CT-32SX31E에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic CT-32SX31E 39 페이지. Na8ml series
Panasonic CT-32SX31E에 대해서도 마찬가지입니다: 서비스 매뉴얼 (31 페이지)
페이지 인쇄
Service Adjustments (Electronic Controls, cont.)
Horizontal Centering (D00)
This Adjustment helps to center the picture horizontally
Preparation:
Connect a monoscope pattern signal.
Procedure:
1. In the Serviceman Mode for making electronic
adjustments. Select the Horizontal Centering
Adjustment DAC (D00) and adjust until the center
of the monoscope pattern is centered on CRT.
2. EXIT the Serviceman Adjustment Mode.
E-W PCC Adjustment (D0C)
This adjustmet helps to correct left and right sides of
picture.
Preparation:
1. Apply a Crosshatch pattern
2. Normalize the Picture Icon Video adjustments.
Procedure:
1. Adjust "D0C" DATA so that the 1st line and 3rd line
make a good balance (See Fig. 32).
Min. Adjustment
Correct Adjustment
Figure 32. E-W PCC Adjustment
Corner PCC Adjustment (D0B)
Preparation:
1. Apply a Crosshatch pattern
2. Normalize the Picture Icon Video adjustments.
Procedure:
1. To adjust upper and lower linearity.
2. Adjust "D0B" to straighten upper and lower lines
(See Fig. 33)
Min. Adjustment
Correct Adjustment
Figure 33. Corner Adjustment
H-Size Adjustment (D0D)
Preparation:
1. Apply a Monoscope pattern
Procedure:
1. Adjust "D0D" DATA so that width "A" and "B"
becomes 5.00
(See Fig. 34).
Note: When using a different pattern, correlate with
Max. Adjustment
V-Size and V-Position Adjustment
(D01 & D06)
Preparation:
1. Apply a Crosshatch pattern.
Procedure:
1. Apply a monoscope pattern.
2. Enter Serviceman Mode
3. Adjust (D06) to center the picture to the marks on
the CRT.
4. Adjust (D01) to make circle of monoscope pattern
a round circle.
V-Linearity Adjustment (D03)
Preparation:
1. Apply a Crosshatch pattern
Max. Adjustment
Procedure:
1. Enter Serviceman Mode, Adjust linearity data
"D03" so that interval of "a" is same as "b" (a=b).
(See Fig. 35)
- 29 -
±
0.40 (when using factory pattern)
4
A
4
5
1
2
6
4
3
5.00
Figure 34. H-Size Adjustment
factory pattern.
a=b
a
b
Figure 35. Linearity adjustment
4
B
4