Diamond Audio D300.2 설치 매뉴얼 - 페이지 11

{카테고리_이름} Diamond Audio D300.2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Audio D300.2 16 페이지. Diamond amplifier installation manual

Trim the power ca bl8 within 18 inches

(t 5. 7mm) of the positive battery post and splice in a in-line

fuse holder. DO NOT install the fuse at this time.

Strip 1/2 inch (12.7mm) from the battery end of the power cable and crimp a large ring terminal to

the cable. Connect the ring terminal to the positive (+) battery post.

Power Connections

WARNING

YOU HUST USE AN OUTBOARD FUSE ON THE D1000.1. THERE ARE NO

ONBOARD FUSES ON THE D1000.1.

THE D1000.1 NEEDS J.N INLINE FUSE RATED AT 100 AHPS.

WHEN US/NO A HULTIPLE AHPLIFIER SYSTEH WITH ONE HAIN POWER WIRE, THE HAIN POWER WIRE CONNECTED TO THE BATTERY

HUST HAVE AN INLINE FUSE RATED EQUAL TO THE SUH OF ALL THE AHPLIFERS INLINE AND ONBOARD FUSES. IN A HULTIPLE

AHPLIFIER SYSTEH THE D1000.1 HUST HAVE AN INLINE FUSE RATED AT 100 AHPS AT THE AHPLIFIER AS WELL AS A HAIN FUSE

LOCATED NEAR THE BATTERY.

Prepare the ground wire

for

attachment to the amplifier n:' stripping 5/8" of insulation from the end

of the wire, Insert the bare wii e into the GND terminal and tighten the set screw to secure the cable

in place. Prepare the chassis ground by scraping any point from the metal

~,urface

and thoroughly

clean the area of all di(t and grease. Strip the other end of the vv1re and =Jttach a ring connector.

Fasten the cable to the chassis using a non-anodized screw and a star washer.

NOTE:

It is important to upgrade the ground connection b2tween the negative(-) battery post and the

vehicle body or chassis to achieve optimum electrical performance.

Prepare the REM turn-on wire for attachment to the amplifier by stripping 5/8 inch (15.9mm) of

!nsulation from the end of the wire. Insert the bare wire into the REM terminal and tighten the set

screw to secure the wire in place. Connect the other end of the REM wire to a switched 12 volt posi-

tive source. The switched voltage is usually taken from the source unit's remote amp on lead. If the

source unit does not have this output available, the recommended solution is to wire a mechanical

switch in line with a 12 volt source to activate the amplifier.

Securely mount the amplifier to the vehicle or amp rack. Be careful not to mount the amplifier on

cardboard or plastic panels. Doing so may enable the screws to pull out from the panel due to road

vibration or sudden vehicle stops.