Diamond Audio HEX480.4 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Diamond Audio HEX480.4에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Audio HEX480.4 16 페이지. Multi-channels

MOUNTING

All Diamond Audio HEX ampliﬁers are designed with hidden mounting . To accomplish this the front and rear alumimum

covers are magnetically attached for easy access. To start the installation/mounting process simply remove the back panel

by pushing towards the rear and pulling up at the same time. The front process is similar but push/pull towards the front

and pull up as shown below

Once the ampliﬁer(s) is mounted input signal cables and speaker/power wires are connected, adjust the input levels and

crossover settings (according to page 9) After all the settings are done, THEN put the front and rear cosmetic covers back

on. As shown below.

BACK COVER

NOTE: These covers are both a friction ﬁt as well as magnetic. There is a small "lip" on the front cover that clamps the

front cover on tightly. Sometimes it can be somewhat hard to remove. Be careful, but forceful.

BACK COVER

FRONT COVER

Mark Ampliﬁer Mounting Holes:

Once the covers are removed, use a pencil

and mark the mounting locations. Both front

and rear. Once marked, drill 1/8" holes for

the included mounting screws. (see below)

MAGNETS

FRONT COVER