Aquasub engineering ADP 03SF 운영 매뉴얼 - 페이지 8
{카테고리_이름} Aquasub engineering ADP 03SF에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquasub engineering ADP 03SF 15 페이지. Submersible dewatering pump. texmo adp series
페이지 인쇄OPERATION PRECAUTIONS
Do not run the pump dry, it could lead to product damage.
Switch off the power supply and ensure the impeller fully stop, before
changing rotation or making any other adjustments.
Do not use this pump for hot liquids exceeding 40°C temperature, it may
lead to product failure.
Do not switch on the pump if there is any human contact with the pumping
water. If any electrical leakage occurs it could be harmful.
TRIAL OPERATION
The Submersible Dewatering pumps
are equipped with float switch which can
automatically switch "on" and "off" the
pump by sensing water level.
Trial operation can be done before installing
the pump in pit, by following below said
procedure,
1.
By default, float switch will be in
downward direction. In this position switch
on the pump, ensure that the pump is in
"off" condition.
2.
Move the float switch upward and
ensure that the pump starts.
3. Move the float downward and ensure
that the pump stops.
Repeat this procedure for 2 to 3 times and ensure that the pump is
working normally.
Ensure the free movement of float switch. Sump wall or any other structure
should not obstruct the free movement of float switch.
If you find any abnormalities like vibration, noise, smell etc.. in the pump
during trial operation, switch off the pump and contact the dealer where
this pump was purchased or the "AQUASUB ENGINEERING's" sales office in
your area.
ON
OFF