Aquasub engineering ADP 07SF 운영 매뉴얼 - 페이지 10
{카테고리_이름} Aquasub engineering ADP 07SF에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquasub engineering ADP 07SF 15 페이지. Submersible dewatering pump. texmo adp series
페이지 인쇄INSTALLATION PRECAUTIONS
PRODUCT INSPECTION
Inspect the purchased pump for damage or leakage during
transportation. And make sure all bolts and nuts are tightened properly.
If you find damage or discrepancy in the product, contact the dealer
where the pump was purchased or the "AQUASUB ENGINEERING's"
sales office in your area.
TYPICAL INSTALLATION
A typical installation diagram is shown below. Please follow the given
installation precautions before and during installation.
Single phase models
For three phase models it is recommended to use a control panel with
single phase prevention, overload relay and control for float switch
operation.
From control panel
(For three phase)
Chain or Rope
Discharge pipe
Cable
Pump
With pump
(For single phase)
Minimum water lavel
Sludge
( Place the pump above sludge)
Three phase models