AquaSure AS-FP1500 소유자 매뉴얼 - 페이지 5
{카테고리_이름} AquaSure AS-FP1500에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaSure AS-FP1500 12 페이지. Whole house water filter
페이지 인쇄
- 1. Table of Contents
- 2. Inspection & Preparation
- 3. Be Familiar with the System before Installation
- 4. System Operation Parameter and Installation Checklist
- 5. Installing the System
- 6. STEP 1. Checking the Direction of Water Flow
- 7. STEP 2. Shutting off the Main Water Supply Valve
- 8. STEP 4. Attaching the Water Supply Pipe
- 9. STEP 5. Installing the Filter
- 10. STEP 6. System Startup
- 11. Limited Product Warranty
II. System Operation Parameter and Installation checklist
IMPORTANT! The following condition for feed water supply must be met or warranty will be
void and manufacturer assumes no responsibility for damage to system or property.
1. Water Temperature Parameter
•
Maximum: 100º F (37.8º C)
•
Minimum: 40º F (4.4º C)
2. Water Pressure Parameter
•
Maximum: 75 PSI (5.98 kg/cm2)
•
Minimum: 20 PSI (1.41 kg/cm2)
3. pH Parameter
•
Maximum: 10
•
Minimum: 5
4. Pre-install environment checklist
•
Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
•
Filtration system must not be installed at an area where it is exposed to direct sunlight
and must be protected against freezing and extreme heat.
•
To prevent possible water damage, housing should be replaced every 4 years.
AQUASURE
FORTITUDE PRO SERIES
3