AquaSure FORTITUDE PRO Series 매뉴얼 - 페이지 7
{카테고리_이름} AquaSure FORTITUDE PRO Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaSure FORTITUDE PRO Series 20 페이지. Whole house water treatment system
AquaSure FORTITUDE PRO Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지)
페이지 인쇄
Recommended Tool List for System Installation
•
Variable Speed Drill
•
Drill Bit
•
Bolt Bit
•
Adjustment Wrench
•
Level Tool
•
Teflon Tape
•
Pen or Pencil
II. System Operation Parameter and Installation checklist
IMPORTANT! The following condition for feed water supply must be met or warranty will be
void and manufacturer assumes no responsibility for damage to system or property.
1. Water Temperature Parameter
•
Maximum: 100º F (37.8º C)
•
Minimum: 40º F (4.4º C)
2. Water Pressure Parameter
*Pressure reducer recommended if PSI exceeds 75 psi.
•
Maximum: 75 PSI (5.98 kg/cm2)
•
Minimum: 20 PSI (1.41 kg/cm2)
3. pH Parameter
•
Maximum: 10
•
Minimum: 5
* A vacuum breaker may be needed for well water installation.
4. Pre-install environment checklist
•
Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
•
Filtration system must not be installed at an area where it is exposed to direct sunlight
and must be protected against freezing and extreme heat.
•
To prevent possible water damage, high flow housing should be replaced every 4 years.
Recommended Parts List for System Installation
•
1" Male Thread Adapter X 4
•
1" Shut Off Valve X 3
AQUASURE
FORTITUDE PRO SERIES
4