DIAMOND DRYERS HD-D380S 사용 설명서 및 부품 설명서 - 페이지 3
{카테고리_이름} DIAMOND DRYERS HD-D380S에 대한 사용 설명서 및 부품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIAMOND DRYERS HD-D380S 6 페이지. Surface mounted high speed hand dryer
페이지 인쇄UNPACKING / STANDARD ACCESSORIES
1.
Remove all packing material. Recycling is recommended.
2.
Carefully remove the hand dryer from the shipping carton, using care not to
drop the appliance.
3.
Use caution when removing the casing. The casing may have sharp edges/
corners which may cut or cause harm.
4.
Inspect carefully for any damage that may have occurred during transit. Check
for any loose, missing or damaged parts. If the hand dryer is damaged, promptly
inform the shipper or dealer where you purchased it.
Standard items included with the hand dryer are:
Main Unit
Service Tool
INSTALLATION
CAUTION
•
Make sure power supply breaker is switched off.
•
All electrical installation and repair work should be carried out by a qualified
electrician or local service Engineer in accordance with current local codes or
regulations.
•
Check that the electrical supply corresponds to that shown on the rating plate.
If the unit is connected to any electrical supply other than stated on the rating
plate of the unit, permanent damage or unsafe operation of the unit may result.
•
The unit must be mounted on a flat vertical wall capable of supporting the full
Main Unit
weight of the unit.
•
Do not use the backplate as a guide when drilling. Ensure no pipe work (gas,
water, air) or electrical cables, wires or ductwork are located directly behind the
Service Tool
drilling/mounting area.
1. UNPACKING
1.1 Place the main cover on a cloth to avoid
marking its surface.
1.2 Remove the (2) security screws from the
main body, using the service tool provided. Store
safely.
1.3 Lift the front cover off the main body.
Grommet
6mm
L
High-Speed Hand Dryer
Installation Manual
Manual
High-Speed Hand Dryer
Installation Manual
Manual
Wall Mouting
anchors
Flat cable clamp
& Screw
Wall Mouting
anchors
Flat cable clamp
& Screw