Aquatec Beluga 조립 지침

{카테고리_이름} Aquatec Beluga에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquatec Beluga 2 페이지. Change of actuator
Aquatec Beluga에 대해서도 마찬가지입니다: 조립 지침 (4 페이지), 조립 지침 (3 페이지), 조립 지침 (4 페이지)

페이지 인쇄

ASSEMBLY INSTRUCTIONS

Assembly of Headrest AQUATEC BELUGA

Please read the entire assembly instructions carefully before beginning the assembly!

DELIVERY ITEMS:

Headrest AQUATEC FORTUNA / BELUGA, white

Consisting of:

4 Mountings (plastic part)

4 Flat-headed screws size Ø 4 x 20 (VA)

1 Bracket – round steel Ø 8 (VA)

1 Cover – woven mat with Velcro fastener

PREPARATION:

For backrest with existing assembly drill holes for mounting the headrest

(4 holes for flat-headed screws and 4 holes for fixing pegs).

1.) have a cross-tip screwdriver size 2 available

2.) unbutton the backrest cover

For backrest without assembly drill holes carry out preparations as described above.

Additional tools required: Suitable electric drill (or battery powered drill), countersink 10x90°, twist

drills Ø 4.2 and Ø 5,1 mm.

WORK STEPS:

1. In accordance with the diagram below drill the 4 centres marked with (a) with a Ø 4.2 mm

twist drill.

2. In accordance with the diagram below drill the 4 centres marked with (b) with a Ø 5.1 mm

twist drill.

3. Countersink the 4 holes with Ø 4.2 mm (pos. a) with the countersink on the front side

(cover side) to Ø 8.5 mm (suitable for screw 4 x 20).

4. Deburr the other drill hole edges on both sides with the countersink.

Updated: 01.01.02/Marketing

16126 Assembly headrest Beluga

Order no. 15461

Part 1

Part 2

Part 3

Part 4

Page 1 of 2

V/Allgemein/Montage/Montageanleitungen/

Deutsch/Beluga/Montage Kopfstütze

Order no. 15407

Order no. 13091

Order no. 15446

Order no: 15466

Part 3

Part 4

4 x Part 1 + 2