Aquatec ELAN AQT00063 사용 설명서 - 페이지 9
{카테고리_이름} Aquatec ELAN AQT00063에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquatec ELAN AQT00063 17 페이지.
페이지 인쇄5.
Turn yourself so that you can be comfortably low-
ered into the water. Lift one leg after the other
over the edge of the bathtub.
6.
Once you are sitting correctly, press the DOWN
button (5, fig. 10) to lower the seat into the water.
To get out of the bath, follow the above steps in re-
verse order.
To lift the seat, press the UP button (3, fig. 10).
7.
Take the battery out of the guide and recharge it
as described in section 5.1 or remove the bathlift
as described in section 5.4.
6.3
Troubleshooting
Important!
The following table provides information on
faults and their probable cause. If you cannot
rectify a fault using the table, please contact
your authorised dealer directly.
Problem
Possible causes
No motor noise/
The battery is not
bathlift does not
properly inserted
move
The battery is flat
The contacts are
dirty
The cable is dam-
aged
The bathlift can be
Low-voltage pro-
raised but not low-
tection is activated
ered
The bathlift stops
The load is exces-
while being raised
sive
The battery can-
The fuse is faulty
not be recharged
The battery is
faulty
The bathlift slips
The suction cups
are old or dam-
aged
EN
Remedy
Insert the battery
(see section 5.3)
Recharge the bat-
tery (see
section 5.1)
Clean the contacts
Have your author-
ised dealer re-
place the cable
Recharge the bat-
tery
Observe the maxi-
mum load
Have your author-
ised dealer check
the battery
Replace the bat-
tery
Replace the suc-
tion cups
7
Care and maintenance
7.1
Seat and backrest
CAUTION!
There is a risk of injury when the lifting scis-
sors move.
Be especially careful when cleaning the
seat.
There is a risk of damage.
Never clean the backrest with a high pres-
sure cleaner.
Important!
●
Regularly clean the seat and backrest and
keep them clean.
●
Do not use abrasive cleaning agents.
1.
Wash the product with commercial detergents and
disinfectants using a cloth or brush.
2.
Rinse the product with warm water.
3.
Dry the product with a cloth.
4.
Lightly grease the track (14, fig. 1) using Vaseline.
5.
Remove the covers (optional) from the seat and
backrest.
CAUTION!
There is a risk of damage.
Do not tumble-dry the covers (optional).
6.
Wash the covers (optional) in the washing ma-
chine at maximum 60 °C using a mild detergent.
7.2
Charger and battery
CAUTION!
There is a risk of injury from electric shock.
●
Before cleaning the charger, always pull
the plug out of the power socket.
●
Never plug objects made of conducting
material (e.g. knitting needles, metal
pins) into the battery socket.
●
Only use a dry cloth to clean the charger
and the battery.
Wipe down the charger and the battery with a dry
cloth.
7.3
Maintenance
The bathlift is maintenance-free provided you follow
the care instructions described above.
8