Aquatec HydroPro HZ2010 빠른 시작 매뉴얼 - 페이지 7
{카테고리_이름} Aquatec HydroPro HZ2010에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquatec HydroPro HZ2010 13 페이지. Air pumps
페이지 인쇄4. Now loosen and remove the nuts on either end of rubber
diaphragms.
5. Swing the metal arms that hold the magnet, away from the
rubber diaphragms. Release both of the rubber diaphragms
from the plastic frame by applying light pressure to the edge of
rubber, to fully release them from groove.
6. Once rubber diaphragms are free from the plastic frame, go
ahead and remove screws from each one of the old rubber
diaphragms and re-insert onto the new rubber diaphragms.
7. Now install both of the new rubber diaphragms onto the plastic
frame securely by applying light pressure until fully seated in
plastic groove all the way around rubber.
8. Next swing the metal arms that hold the magnet back into
position towards the rubber diaphragms, making sure to line
up the holes with threads from screws in center of rubber
diaphragms.
9. Now install and tighten the nuts on either end of diaphragms.
Take care not to over-tighten.
HPRO Air Pump Z2010_Z4010 Instructions.indd 7
INSTRUCTION MANUAL
V I S I T A Q U A T E C E Q U I P M E N T . C O M
AIR PUMP
22/2/19 11:07 am