3C Concept TC-SPLIT 사용자 설명서 - 페이지 5
{카테고리_이름} 3C Concept TC-SPLIT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3C Concept TC-SPLIT 12 페이지.
페이지 인쇄3.3 – Unipolar encoder (open collector or unipolar TTL/HTL outputs), not isolated
3.4 – Unipolar encoder (open collector or unipolar TTL/HTL outputs), isolated
Encoder ouput level: 5V/TTL
switch in low pos. (ON)
Encoder ouput level: 10-30Vdc
switch in high pos.(OFF)
Unipolar wiring must not be used with long cabling distance or within high electromagnetic
environments.
Input voltage must not be greater than 8V if switches are in low position
Never set jumpers vertically
Never set external power on [P1.7; P1.8] if jumpers are populated
Wiring colours used above are not standardized, double check datasheet of the
encoder for correct wiring
After module power up, it is possible to check the operation by slowly moving the
encoder axis, the 3 leds on the side of the TC-SPLIT should blink.
3C Concept S.A.S
TC-SPLIT USER MANUAL
Jumper pos. for powering
encoder with 5Vdc
Jumper pos. for powering
encoder with 24Vdc
1
A
A
B
B
Z
Z
0V_EXT
+V_EXT
Encoder ouput level: 5V/TTL
switch in low pos. (ON)
Encoder ouput level: 10-30Vdc
switch in high pos.(OFF)
1
A
A
B
B
Z
Z
0V_EXT
+V_EXT
+V
Encoder power supply
5
5
Encoder or signals
source
Encoder or signals
source
TC-SPLIT_MANUEL_EN_105.DOCX